Gate score is 358. Can I get admission in NIT for mtech(CE).
Take part in counseling so that you can good college based on your rank
You can check your chances in various colleges based on your score and category, y ou should try Careers360 college predictor and rank predictor.
Link for C areers360 rank predictor:- https://engineering.careers360.com/gate-college-predictor
All the very best and good luck.
As u havnt specified your cast let me cover up all the grounds..If u ar an sc/st candidate.. woalaahh there is a lot of chance u know as obvious... But if u are a general candidate then lets say there is a bit of a chance and that to probably in newer nits... but hey dont listen to any one unless and untill u yourself see the cutoof of every college.. plus there is this NSR round in ccmt where the possibility to get a seat remains... plus this year onward ALL the IITs and a few PSU's are coming under COAP so there might be some people who earlier didnt get iit might get a set there or in a PSU say and there fore some of the seats in NIT which until last year was acquired by those above said candidates will remain free this year... so u still got a chance bro.. only key is to apply in every place be it CCMT or COAP or even PSUs..... u dont know but u might just get luckyyyy... all the best pal:)
Chances should be below average so you are advised to use below provided Gate college predictor to know all your best possible admission possibilities -
Https://engineering.careers360.com/gate-college-predictor
Good Luck!!!
Seriously SC and ST people are the most previliaged in this aspect...their cut off is almost 10 marks less than general category..
And if you qualify gate just apply CCMT, you will definitely get seat in any Nit at least spot councelling..don't listen to people who say that you won't get into any with this score and all such bull shit comments...and regret after every thing goes out from your hand..if just getting mtech seat is your priority...else depends on the area...usually design, thermal are hot cakes...you can't get them unless your score is 550+ for obc and 640+ for general...the cutoff purely depends on the area and college...
Related Questions
Know More about
Graduate Aptitude Test in Engineering
Eligibility | Application | Exam Pattern | Admit Card | Preparation Tips | Books | Question Paper | Accepting Colleges
Get Updates BrochureYour Graduate Aptitude Test in Engineering brochure has been successfully mailed to your registered email id “”.